My friend is locked inside her flat, landlord isn’t answering calls. Any ideas of what to do would be really appreciated! Apparently it’s just completely stuck, she can’t move the handle bit or the latch thing (technical terms I’m sure!) : Locksmith


Common fault with these. If the snib (small button-like thing) won’t move, there’s nothing she can do except call a locksmith. They will drill from the outside, release and replace. If it’s ground floor, they should try to climb through a window and do it from inside as it will save the cylinder.

You friend should take a video that shows it’s jammed and screenshot her phone’s call log to prove that she attempted to contact the landlord.

Expect to pay a total of £150-£200 or so to have this done tonight. It should all be recoverable from the landlord but if you have trouble with that, post on r/legaladviceuk

Make sure you get a full price over the phone from the locksmith and follow the advice in the sidebar to see how to find a good one. Easy to quote this from photos so don’t put up with any nonsense from people that tell you they have to wait until they are on site.

(I’ve assumed UK, judging by the your lock)



Source link

Key Duplicator Drill Bit : Locksmith


Hi All,

I’ve recently ressurected a laser key duplicator which we haven’t used in years.

The supplier we used to use for consumables is no longer trading and I’m not sure what I should be searching for to find a replacement drill bit.

The bit reads “2.5 co8 STg 13.60”

I have also attached a picture for reference: https://ibb.co/Z8RQdgK

What should I be looking for and where might I find it? The machine is a Curtis Industries LC3.

Thanks!



Source link

The bars on this lock fall down a little bit and it’s VERY annoying! It still works, but I would like to be able to close my door without turning the knob every time. Any easy fixes? : Locksmith


Not sure if you can get a look on the inside, but if you can then youll be able to visibly see whats allowing it to drop slightly. My guess is the metal is probably slightly stretched or its loose at the thumbthurn causing the bolt to drop slightly when the knob is finally at its resting position.



Source link

Grandfathers Microscope that I haven’t seen in 30 years. I think this is the key. It has a bit of spring when it turns, but won’t open. Bad mechanism, bad key… who knows. Need some guidance, so I can share it with my kid as my parents did with me. I do have a 3d printer… just sayin. : Locksmith


level 2

I tried all locations with it… doesnt seem to make a difference. I did notice that the little metal piece that the key goes over is loose and wiggles. I was wondering if that can be tightened and could cause a problem?



Source link

Found this padlock in a shed, no key. Tried to pick the lock, but the core is not moving one bit under tension, and seems rusted shut. All of the 6 pins feel springy, and nothing is binding since the core is not moving. Recommendations? WD-40? Attack it with fire? Other?


Found this padlock in a shed, no key. Tried to pick the lock, but the core is not moving one bit under tension, and seems rusted shut. All of the 6 pins feel springy, and nothing is binding since the core is not moving. Recommendations? WD-40? Attack it with fire? Other? submitted by /u/Mis_Tral
[comments]



Source link

Call Now ButtonCall Now!