Key snapped in this lock. Any suggestions to remove? I tried removing the handle on both sides but lock goes right through. Tried jabbing the bottom of the key hole with thin metal screw heads. Am stuck : Locksmith


I get calls like this all the time. It’s always worse when the customer has been poking, prodding and scraping at things. Just bite the bullet and call a locksmith because this requires specialist tools. They will also tell you what’s needed to stop it happening again, because there is almost always an underlying cause when a key snaps.



Source link

Deadbolt hole drilled too deep? : Locksmith


I took measurements and it all checks out, thank you! I lost my key and had a locksmith come in to repin the lock, and he also went ahead and made adjustments to the deadbolt. For a min I thought he unnecessarily put a hole in my house, but good to know I got a more secure working deadbolt out of it too! The locks were always a bit sticky, and I swear a couple times after locking I came back to an open door. I thought it was so strange, but that explains it.



Source link

Lever lock (“skeleton key”) for a 7/8″ cabinet hole? : Locksmith


I’m curious if anyone knows of a ole-tyme style lock that can be swapped in place of something like a Prime-Line U 9947? This is more about style than security, so even a cigar-box style lock would work. Everything I’ve found requires mortising or a larger diameter hole and I’m dealing with a relatively small amount of wood/space in the cabinet I’m trying to repair.

Adding some pictures: https://imgur.com/a/WI8OYni



Source link

What is that knob in my SentrySafe blocking the door pocket? There’s an access hole at 11 o’clock. : Locksmith


I have searched far and wide and can’t find any info. My guess is that one pokes a wire through the hole and presses on some plate, which would probably then allow the the knob to turn clockwise it looks like … and then what happens? I’m not adventurous enough to find out.



Source link

Deadbolt options for a rental house? 1.5 inch bore hole : Locksmith


Moving to a rental house and wanted to change the locks out and realized today that the bore hole is 1.5″.

Ideally I want a lock with a pin pad or something similar. Does anyone know locks like that that would fit? I’ve been looking for a couple hours and can’t find anything, but I might not be searching for the right terms. Maybe other options (adapters?)

I have the tools to drill a bigger hole but don’t want to do that if I can avoid it.

Thank you!



Source link

What are my chances of finding a replacement: Thin Euro style Mortise lock for a metal security door with 2 different backsets. Handle hole is 25mm and Cylinder is 30mm. Brand is Himco, used in Los Angeles area probably 30-40+ years ago.


What are my chances of finding a replacement: Thin Euro style Mortise lock for a metal security door with 2 different backsets. Handle hole is 25mm and Cylinder is 30mm. Brand is Himco, used in Los Angeles area probably 30-40+ years ago. submitted by /u/avtechguy
[comments]



Source link

Doing some shop cleaning today and I came across this. Anyone know what the hole in the tip does when inserted into the lock? : Locksmith


My only guess is some kind of warding, but it seems useless that far back and with such a limited area of contact. It might prevent bumping, but it wouldn’t stop a pick. I honestly don’t know if that’s not it. I assume you don’t have the accompanying lock.



Source link

Call Now ButtonCall Now!